Toyota Sienna Service Manual: Front lower suspension arm

Disposal

1. DISPOSE OF SHOCK ABSORBER ASSEMBLY FRONT LH HINT: Dispose the RH side by the same procedures as the LH side. (a) Fully extend the shock absorber rod. (b) Using a drill, make a hole in the cy ...

Removal

1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE HINT: (See page EM-34) 2. REMOVE TRANSVERSE ENGINE ENGINE MOUNTING INSULATOR (a) Remove the 3 nuts and transverse engine engine mounting insulator. 3 ...

Other materials:

Circuit inspection
A description of the main areas of each circuit inspection is shown in the table below. Item Description Circuit Description The major role, operation of the circuit and its component parts are explained. Diagnostic Trouble Code No. and Detection item Indicates ...

Cleaning and protecting the vehicle exterior
Perform the following to protect the vehicle and maintain it in prime condition: Working from top to bottom, liberally apply water to the vehicle body, wheel wells and underside of the vehicle to remove any dirt and dust. Wash the vehicle body using a sponge or soft cloth, such as a cha ...

Installation
1. INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) (a) Using SST, install the sensor to the exhaust manifold LH. SST 09224-00010 Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf) for use with SST 44 N*m (449 kgf*cm, 32 ft.*lbf) for use without SST HINT: Use a torque wrench with a fulcrum ...