COMPONENTS
ON-VEHICLE INSPECTION
1. INSPECT FRONT NO.2 SPEAKER
HINT: Remove interior parts so that the front No.2 speaker can be seen.
OK: The speaker is securely installed.
If the result is not as specified, reinstall the front No.2 speaker.
OK: The cone paper of the speaker is not torn.
If the result is not as specified, replace the front No.2 speaker.
REMOVAL
1. REMOVE INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
2. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY
INSTALLATION
1. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY
NOTICE: Tighten the screws in order shown in the illustration to install the front No. 2 speaker assembly.
2. INSTALL INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
Disassembly
1. REMOVE REAR DOOR WINDOW FRAME MOULDING
REAR LH (See page ET-31)
2. REMOVE REAR DOOR WINDOW FRAME MOULDING
SUB-ASSEMBLY LH (See page ET-32)
3. REMOVE SLIDE DOOR WINDOW GARNISH LH
Fully open the slide door window.
Remove the glass run.
Using a screwdriver, disengage the clip and rem ...
Steering Angle Sensor Circuit Malfunction
DTC C1231/31 Steering Angle Sensor Circuit Malfunction
DESCRIPTION
The steering angle sensor signal is sent to the skid control ECU through the
CAN communication system.
When there is a malfunction in the communication, it will be detected by the
diagnosis function.
WIRING DIAGRAM
INS ...
Throttle / Pedal Position Sensor / Switch "A" Circuit Range / Performance
Problem
HINT:
This DTC relates to the Throttle Position (TP) sensor.
DESCRIPTION
Refer to DTC P0120 (See page ES-145).
MONITOR DESCRIPTION
The ECM uses the TP sensor to monitor the throttle valve opening angle.
This sensor transmits two signals: VTA1 and VTA2. VTA1 is used to detect the
th ...