DTC B1785 Front Occupant Classification Sensor LH Collision Detection
DESCRIPTION DTC B1785 is output when the occupant classification ECU receives a collision detection signal sent by the front occupant classification sensor LH if an accident occurs.
DTC B1785 is also output when the front seat assembly RH is subjected to a strong impact, even if an actual accident does not occur.
However, when the occupant classification ECU outputs a collision detection signal, even if the vehicle is not in a collision, DTC B1785 can be cleared by "Zero point calibration" and "Sensitivity check".
Therefore, if DTC B1785 is output, first perform "Zero point calibration" and "Sensitivity check".
WIRING DIAGRAM
INSPECTION PROCEDURE
1 PERFORM ZERO POINT CALIBRATION
OK: "COMPLETED" is displayed.
2 PERFORM SENSITIVITY CHECK
Standard value: 27 to 33 kg (59.52 to 72.75 lb)
3 CHECK DTC
OK: DTC B1785 is not output.
HINT: Codes other than DTC B1785 may be output at this time, but they are not related to this check.
4 REPLACE FRONT SEAT ASSEMBLY RH
HINT: Perform the inspection using parts from a normal vehicle if possible.
5 PERFORM ZERO POINT CALIBRATION
OK: "COMPLETED" is displayed
6 PERFORM SENSITIVITY CHECK
Standard value: 27 to 33 kg (59.52 to 72.75 lb)
7 CHECK DTC
HINT: First clear DTCs stored in the occupant classification ECU and then in the center airbag sensor assembly.
OK: DTC B1785 is not output.
HINT: Codes other than DTC B1785 may be output at this time, but they are not related to this check.
8 REPLACE OCCUPANT CLASSIFICATION ECU
9 PERFORM ZERO POINT CALIBRATION
OK: "COMPLETED" is displayed.
10 PERFORM SENSITIVITY CHECK
Standard value: 27 to 33 kg (59.52 to 72.75 lb)
END
Short to B+ in Front Pretensioner Squib LH Circuit
DTC B0138/72 Short to B+ in Front Pretensioner Squib LH Circuit
DESCRIPTION
The front pretensioner squib LH circuit consists of the center airbag sensor
assembly and the front seat
outer belt assembly LH.
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B01 ...
Noise Occurs from Generator while Engine is Running
INSPECTION PROCEDURE
1 CHECK LOOSENESS OF V-RIBBED BELT
(a) Check the tension of the belt by pushing it down with a
finger.
OK:
The tension of the belt is enough.
2 CHECK V-RIBBED BELT FOR WEAR
(a) Check the V-ribbed belt for wear.
OK:
The V-ribbed belt is not worn.
3 CHECK CLUTC ...
Short to B+ in Front Pretensioner Squib RH Circuit
DTC B0133/62 Short to B+ in Front Pretensioner Squib RH Circuit
DESCRIPTION
The front pretensioner squib RH circuit consists of the center airbag sensor
assembly and the front seat
outer belt assembly RH.
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B01 ...