Inspection
1. INSPECT FRONT POWER SEAT LUMBAR SWITCH
Standard resistance
If the result is not as specified, replace the switch.
A/F sensor and ho2s monitors
(a) Preconditions
The monitor will not run unless:
2 minutes or more have elapsed since the engine
was started.
The Engine Coolant Temperature (ECT) is 75°C
(167°F) or more.
Cumulative driving time at a vehicle speed of 30
mph (48 km/h) or more exceeds 6 minutes.
Air-fuel ratio fe ...
Removal
NOTICE:
Always wear safety gloves because the edges of the
seatback frame and seat adjuster are sharp and may
cause injury.
Work must be started more than 90 seconds after the
ignition switch is turned to the LOCK position and the
negative (-) terminal cable is disconnected ...
On-vehicle inspection
1. CHECK POWER MIRROR SWITCH OPERATION
Remote control
The mirror adjust switch can control the adjustment
axis of the mirror surface.
Reverse-linked
This function tilts the mirror surface downward to
improve the visibility when driving in reverse,
provided that all the co ...