Toyota Sienna Service Manual: Front speed sensor

Installation

1. INSTALL BRAKE ACTUATOR (a) Install the brake actuator assembly with the 2 nuts. Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 2. INSTALL BRAKE ACTUATOR WITH BRACKET (a) Install the actuator wit ...

Removal

HINT: Remove the RH side by same procedures with LH side. 1. REMOVE FRONT WHEEL 2. REMOVE FRONT FENDER LINER LH 3. REMOVE FRONT SPEED SENSOR LH (a) Disconnect the speed sensor connector. ( ...

Other materials:

Short to GND in Side Squib LH Circuit
DTC B0117/45 Short to GND in Side Squib LH Circuit DESCRIPTION The side squib LH circuit consists of the center airbag sensor assembly and the front seat side airbag assembly LH. This circuit instructs the SRS to deploy when deployment conditions are met. DTC B0117/45 is recorded when a s ...

Diagnosis system
1. BUS CHECK Select "BUS CHECK" from the "OBD/MOBD MENU" screen. HINT: The ECUs and sensors that are properly connected to the CAN communication system can be displayed using the intelligent tester via the CAN VIM. Press "ENTER" on the intelligent te ...

Rear Air Conditioning Control Panel Circuit
DESCRIPTION This is the rear A/C system control signal circuit as well as the power supply circuit of the rear A/C control assembly. Pulse signals regarding rear A/C control panel switch operation are transmitted between the A/C amplifier and rear A/C control assembly. WIRING DIAGRAM ...