Toyota Sienna Service Manual: Front wiper rubber
COMPONENTS
REMOVAL
1. REMOVE FRONT WIPER BLADE
- Remove the front wiper blade from the front wiper arm LH.
NOTICE: Do not fold down the front wiper arm with the front wiper blade being removed from it.
2. REMOVE FRONT WIPER RUBBER
- Remove the front wiper rubber from the front wiper blade.
- Remove the 2 wiper rubber backing plates from the front wiper rubber.
INSTALLATION
1. INSTALL FRONT WIPER RUBBER
- Install the wiper rubber backing plates to the front wiper rubber.
NOTICE: Be careful about the right side and the wrong side of the backing plates.
- Install the front wiper rubber so that the head part (Larger side) of the wiper rubber faces the arm axle side.
NOTICE: Push the front wiper blade into the grooves of the wiper rubber to engage them completely.
Installation
1. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY
Apply MP grease to the crank arm pivot of the
windshield wiper motor assembly.
Install the windshield wiper motor assembly with the
...
Rear wiper motor and bracket
COMPONENTS
REMOVAL
1. REMOVE REAR WIPER ARM
Remove the rear wiper arm head cap from the rear
wiper arm.
Remove the nut and the rear wiper arm.
2. REMOVE BACK DOOR GARN ...
Other materials:
Surround View with
Parking Assistant Plus
Concept
The system provides assistance in parking and
maneuvering. The area around the vehicle is
shown on the Control Display.
General information
Several cameras capture the area from different
selectable perspectives. In addition, assistance
functions, for instance guidelines, can be faded
into t ...
Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2. REMOVE HEATED OXYGEN SENSOR (for Bank 1
Sensor 2) (See page EC-38)
3. REMOVE TAIL EXHAUST PIPE ASSEMBLY
(a) Remove the 2 bolts.
(b) Disconnect the 4 exhaust pipe supports and remove
the tail exhaust pipe assembly.
(c) Remove the gas ...
Cursor or Map Rotates when Vehicle Stopped
INSPECTION PROCEDURE
1 CHECK CONDITION
Check with the customer if the vehicle has been turned
by a turntable.
OK:
Vehicle has not been turned by turntable.
HINT:
If the vehicle is turned on a turntable with the ignition
switch on, the system may store the angular velocity. As
a ...
