Toyota Sienna Service Manual: Fuel pump

Removal

1. DISCHARGE FUEL SYSTEM PRESSURE HINT: See page FU-1. 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 3. REMOVE NO. 1 ENGINE UNDER COVER 4. DRAIN ENGINE COOLANT (See page CO-6) 5. REMOVE FR ...

Components

...

Other materials:

Starting the engine
Shift the shift lever to P and apply the brakes. Touch the Toyota emblem side of the electronic key to the engine switch. An alarm will sound to indicate that the start function cannot detect the electronic key that is touched to the engine switch if any of the doors is opened ...

Installation
1. INSTALL STEERING ANGLE SENSOR (a) Install the steering sensor onto the spiral cable. 2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 3. INSTALL SPIRAL CABLE SUB-ASSEMBLY (See page RS-434) 4. INSTALL STEERING COLUMN COVER LWR (See page RS-435) 5. CENTER SPIRAL CABLE (See page RS-435) 6. IN ...

Short to B+ in CAN Bus Line
DESCRIPTION A short to B+ is suspected in the CAN bus wire when the resistance between terminals 6 (CANH) and 16 (BAT), or terminals 14 (CANL) and 16 (BAT) of the DLC3 is below 6 kΩ. Symptom Trouble Area The resistance between terminals 6 (CANH) and 16 (BAT), or ...