Components
REMOVAL
1. REMOVE FUEL PUMP RESISTOR
(a) Disconnect the connector.
(b) Remove the nut and fuel pump resistor.
INSPECTION
1. INSPECT FUEL PUMP RESISTOR
(a) Inspect fuel pump resistor.
(1) Using an ohmmeter, measure the resistance between the terminals.
Standard resistance
INSTALLATION
1. INSTALL FUEL PUMP RESISTOR
(a) Install the fuel pump resistor with nut.
Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) (b) Connect the connector.
On-vehicle inspection
1. CHECK AUTO SLIDE-OPEN / CLOSE FUNCTION
Check that the sliding roof switch can operate the
sliding roof glass as follows while the tilt-up / DOWN
function is not operating.
Standard
HINT:
The sliding roof stops partway when the sliding roof
switch is pushed on either side during AU ...
Engine immobiliser system
PARTS LOCATION
SYSTEM DESCRIPTION
The engine immobiliser system has been designed to prevent
the vehicle from being stolen. This system uses a
transponder key ECU that stores the key code of the
authorized ignition key. If an attempt is made to start the
engine using a non-authorized key, ...
Scratched / Reversed Disc
DTC 44-46 Scratched / Reversed Disc
DESCRIPTION
DTC No.
DTC Detecting Condition
Trouble Area
44-46
Scratches or dirt is found on DVD surface or DVD is set
upside down.
DVD
Television display assembly
INSPECTION PROCEDURE
HI ...