Toyota Sienna Service Manual: Gateway ECU Communication Stop Mode

Toyota Sienna Service Manual / Can communication / Can communication system / Fail-safe chart / Gateway ECU Communication Stop Mode

DESCRIPTION

Detection Item	Symptom	Trouble Area
Gateway ECU Communication Stop Mode	"Gateway" is not displayed on the "Communication Bus Check" screen of the intelligent tester Applies to "Gateway ECU Communication Stop Mode" in the "DTC COMBINATION TABLE"	Power source circuit of gateway ECU Gateway ECU branch wire or connector Network Gateway ECU

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

NOTICE:

Turn the ignition switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT: Operating the ignition switch, any switches, or any doors triggers related ECU and sensor communication with the CAN. This communication will cause the resistance value to change.

1 CHECK OPEN IN CAN BUS WIRE (ECU MAIN BUS WIRE)

CHECK OPEN IN CAN BUS WIRE (ECU MAIN BUS WIRE)

Turn the ignition switch off.
Disconnect the network gateway ECU connector.
Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

2 CHECK WIRE HARNESS (IG, BATT, GND)

CHECK WIRE HARNESS (IG, BATT, GND)

Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

Measure the voltage according to the value(s) in the table below.

Standard voltage

Standard voltage

REPLACE NETWORK GATEWAY ECU

Distance Control ECU Communication Stop Mode

DESCRIPTION Detection Item Symptom Trouble Area Distance Control ECU Communication Stop Mode Distance control" is not displayed on the &qu ...

Steering Angle Sensor Communication Stop Mode

DESCRIPTION Detection Item Symptom Trouble Area Steering Angle Sensor Communication Stop Mode "Steering angle sensor" is not displayed on ...

Other materials:

Diagnosis system
1. CHECK DLC3 The vehicle's ECU uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format. NOTICE: *: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not ...

Open in Occupant Classification ECU Battery Positive Line
DTC B1794 Open in Occupant Classification ECU Battery Positive Line DESCRIPTION This circuit consists of the occupant classification ECU and the power source circuit (battery, fuse, wire harness). DTC B1794 is recorded when a malfunction is detected in the occupant classification ECU or t ...

Installing the spare tire
Remove any dirt or foreign matter from the wheel contact surface. If foreign matter is on the wheel contact surface, the wheel nuts may loosen while the vehicle is in motion, causing the tire to come off. Install the tire and loosely tighten each wheel nut by hand by ...