Toyota Sienna Service Manual: Gyro Error

Toyota Sienna Service Manual / Navigation / Navigation system / Diagnostic trouble code chart / Gyro Error

DTC 58-10 Gyro Error

DTC 80-10 Gyro Error

DESCRIPTION

DTC No.	DTC Detection Condition	Trouble Area
58-10	Ground short, power supply short, or open circuit in the gyro signal	Gyro sensor Radio and navigation assembly
80-10	Ground short, power supply short, or open circuit in the gyro signal	Gyro sensor Radio and navigation assembly

INSPECTION PROCEDURE

HINT: After the inspection is completed, clear the DTCs.

1 CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)

CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)

Enter the "Navigation Check" mode (Vehicle Sensors).
Check the gyro voltage.

Standard voltage: 0.1 to 4.5 V

2 CLEAR DTC

Clear the DTCs

3 RECHECK DTC

Recheck for DTCs and check if the same trouble occurs again.

HINT: If DTCs are detected frequently, replace the radio and navigation assembly.

OK: Malfunction disappears

END

Bluetooth Module Initialization Failed

DTC 57-47 Bluetooth Module Initialization Failed DESCRIPTION DTC No. DTC Detection Condition Trouble Area 57-47 Bluetooth module is not installed. ...

GPS Receiver Error

DTC 58-11 GPS Receiver Error DTC 80-11 GPS Receiver Error DESCRIPTION DTC No. DTC Detection Condition Trouble Area 58-11 RTC, ROM, and RAM of the GPS r ...

Other materials:

Smart key system
The following operations can be performed simply by carrying the electronic key on your person, for example in your pocket. The driver should always carry the electronic key. Locks and unlocks the doors Front door handles Sliding door handles Back door Starts and stops the ...

Rear Clearance Sonar Sensor LH Circuit
DESCRIPTION An ultrasonic sensor consists of a sensor portion that transmits and receives ultrasonic waves and a preamplifier that amplifies them. The ultrasonic sensor outputs the ultrasonic waves and sends the received signals to the clearance warning ECU. WIRING DIAGRAM INSPECTION PR ...

Freeze frame data
1. FREEZE FRAME DATA (a) The vehicle (sensor) status, stored during ABS and/ or VSC operation or at the time of an error code detection, can be displayed by the intelligent tester. (b) Only one record of freeze frame data is stored and the freeze frame data generated during ABS and/or VSC op ...