Toyota Sienna Service Manual: Headlight leveling switch
ON-VEHICLE INSPECTION
1. HEADLIGHT LEVELING SWITCH
- Connect the battery positive (+) lead to the terminal 1 and the battery negative (-) lead to the terminal 5.
- Measure the resistance between the terminal 4 and the battery negative (-) lead when headlight leveling switch is operated.
- Measure the resistance between the terminal 5 and the battery negative (-) lead when headlight leveling switch is operated.
Voltage
- Inspect switch illumination.
- Connect the battery positive (+) lead to the terminal 3 and the battery negative (-9 lead to the terminal 6, and check that the illumination comes on.
Hazard warning switch
INSPECTION
1. HAZARD WARNING SIGNAL SWITCH ASSEMBLY
Check that there is resistance between the
terminals at each switch position as shown in the
chart.
Resistance
Inspect ...
Stop light switch
ON-VEHICLE INSPECTION
1. STOP LIGHT SWITCH ASSEMBLY
Check the resistance between the terminals at each
switch position as shown ion the chart.
Resistance
...
Other materials:
Disassembly
1. Remove repair service starter kit
(a) Remove the nut and disconnect the lead wire from
the repair service starter kit.
(b) Remove the 2 screws which are used to secure the
repair service starter kit to the repair service starter
kit.
(c) Remove the repair service starter kit.
( ...
Reassembly
1. INSTALL LOWER RADIATOR GRILLE
Engage the 16 claws to install the lower radiator
grille to the front bumper cover.
2. INSTALL FRONT BUMPER HOLE COVER LH (w/o
Fog Light)
Engage the 2 pins to install the front bumper hole
cover LH to the front bumper cover.
3. INSTALL FRON ...
Inspection
1. INSPECT NO. 1 VALVE ROCKER ARM SUBASSEMBLY
(a) Turn the roller by hand to check that it turns
smoothly.
HINT:
If the roller does not turn smoothly, replace the valve
rocker arm sub-assembly.
2. INSPECT VALVE LASH ADJUSTER ASSEMBLY
NOTICE:
Keep the lash adjuster free of dirt ...
