Toyota RAV4 manuals

Toyota Sienna Service Manual: Headlight Relay Circuit

DESCRIPTION

The Multiplex network body ECU controls HEAD relay when signal is received from headlight dimmer switch assembly.

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

1 PERFORM ACTIVE TEST BY INTELLIGENT TESTER

  1. Connect the intelligent tester to DLC3.
  2.  Turn the ignition switch ON and push the intelligent tester main switch ON.
  3.  Select the item below in the ACTIVE TEST and then check that the relay operates

BODY NO. 1:

BODY NO. 1

2 INSPECT HEADLIGHT RELAY

 INSPECT HEADLIGHT RELAY

  1. Inspect headlight relay continuity.

Resistance

Resistance

3 INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

  1. Measure voltage between the terminal as shown in the chart below

Voltage

Voltage

INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

REPAIR OR REPLACE HARNESS OR CONNECTOR

Ignition Switch Circuit
DESCRIPTION The Multiplex network body ECU receives the ACC and IG signals from the ignition switch. WIRING DIAGRAM INSPECTION PROCEDURE 1 READ VALUE OF INTELLIGENT TESTER Connect the in ...

DRL Relay Circuit
DESCRIPTION The Multiplex network body ECU controls the DRL No.2 relay WIRING DIAGRAM INSPECTION PROCEDURE 1 PERFORM ACTIVE TEST BY INTELLIGENT TESTER Connect the intelligent tester to DLC ...

Other materials:

Front Occupant Classification Sensor LH Collision Detection
DTC B1785 Front Occupant Classification Sensor LH Collision Detection DESCRIPTION DTC B1785 is output when the occupant classification ECU receives a collision detection signal sent by the front occupant classification sensor LH if an accident occurs. DTC B1785 is also output when the front ...

Registering and connecting from the “Bluetooth* Setup” screen
To display the screen shown below, press the “SETUP” button and select “Bluetooth*” on the “Setup” screen. Select to connect the device to be used with audio system. Select to register a Bluetooth® device to be used with audio system. Select to set detailed Blueto ...

Short to GND in Rear Curtain Shield Squib RH Circuit
DTC B1632/81 Short to GND in Rear Curtain Shield Squib RH Circuit DESCRIPTION The rear curtain shield squib RH circuit consists of the center airbag sensor assembly and the curtain shield airbag assembly RH. The circuit instructs the SRS to deploy when deployment conditions are met. DTC ...

© 2011-2024 Copyright www.tsienna.net