Toyota Sienna Service Manual: High pitched horn
COMPONENTS
REMOVAL
1. REMOVE FRONT BUMPER COVER
2. REMOVE HIGH PITCHED HORN
- Disconnect the connector.
- Remove the bolt and horn.
INSPECTION
1. INSPECT HIGH PITCHED HORN
- Apply battery voltage and check operation of the horn, as shown in the table.
Standard
INSTALLATION
1. INSTALL HIGH PITCHED HORN
- Install the high pitched horn with the bolt.
Torque: 20 N*m (199 kgf*cm, 15 ft.*lbf)
- Connect the connector.
2. INSTALL FRONT BUMPER COVER
Low pitched horn
COMPONENTS
REMOVAL
1. REMOVE FRONT BUMPER COVER
ET-3
2. REMOVE LOW PITCHED HORN
Disconnect the connector.
Remove the bolt and horn.
INSPECTION
1. INSPECT LOW PITCHED HORN
...
Other materials:
On-vehicle inspection
1. INSPECT CENTER AIRBAG SENSOR ASSEMBLY
(VEHICLE NOT INVOLVED IN COLLISION)
Perform a diagnosis system check.
2. INSPECT CENTER AIRBAG SENSOR ASSEMBLY
(VEHICLE INVOLVED IN COLLISION AND AIRBAG
HAS NOT DEPLOYED)
Perform a diagnosis system check.
3. INSPECT CENTER AIRBAG ...
Adjustment procedure
Second seat
Tip-up seat (7-passenger models)
Seat position adjustment
lever
Seatback angle adjustment
lever
Tip-up seat (8-passenger models)
Seat position adjustment
lever
Seatback angle adjustment
lever
Ottoman seat
Seat position adjustment
...
Steering Angle Sensor Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Steering Angle Sensor
Communication Stop
Mode
"Steering angle sensor" is not displayed on the
"Communication Bus Check" screen of the
intelligent tester
Applies to &qu ...
