Toyota Sienna Service Manual: Horn relay
INSPECTION
1. INSPECT HORN RELAY
- Remove the horn relay from the instrument panel J/ B.
- Measure the horn relay continuity.
Standard
Horn system
PARTS LOCATION
PROBLEM SYMPTOMS TABLE
HORN SYSTEM
...
Low pitched horn
COMPONENTS
REMOVAL
1. REMOVE FRONT BUMPER COVER
ET-3
2. REMOVE LOW PITCHED HORN
Disconnect the connector.
Remove the bolt and horn.
INSPECTION
1. INSPECT LOW PITCHED HORN
...
Other materials:
Distance Control ECU Power Source Circuit
DESCRIPTION
This circuit provides power to operate the distance control ECU. The distance
control ECU determines
information about the vehicle in front based on data from the laser sensor, and
then decides how much
acceleration and/or deceleration is needed to maintain the set distance. The
...
Outside vehicle
General maintenance
Check the parts of the vehicle described below on a daily
basis. Performing maintenance checks on the vehicle is the
owner's responsibility. The owner may take the vehicle to a
service center but it is recommended that the owner perform
the checks.
In most cases, special ...
Installation
1. INSTALL PROPELLER W/CENTER BEARING SHAFT ASSEMBLY
(a) Align the matchmarks on the propeller shaft
assembly rear flange and differential companion
flange, and connect the shaft with the 4 bolts,
washers and nuts.
(b) Remove SST(s) from the extension housing.
(c) Insert the yoke int ...
