Toyota Sienna Service Manual: How to proceed with
troubleshooting
HINT:
- Use this procedure to troubleshoot the engine immobiliser
system.
- The intelligent tester should be used in steps 4, 5 and 7.
1 VEHICLE BROUGHT TO WORKSHOP
2 CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK
3 CRANK ENGINE FOR MORE THAN 10 SECONDS
4 CHECK FOR DTC
- Check for DTCs and note any codes that are output.
- Delete the DTC.
- Recheck for DTCs. Try to prompt the DTC (SFI system
and engine immobiliser system) by simulating the
original activity that the DTC suggested.
- If the DTC does not reoccur, proceed to A.
- If the DTC (SFI system) reoccurs, proceed to B.
- If the DTC (engine immobiliser system) reoccurs,
proceed to C.
5 READ VALUE OF INTELLIGENT TESTER ((IMMOBILISER ECU (TRANSPONDER KEY ECU
ASSEMBLY) (SWITCH CONDITION))
- Connect the intelligent tester to the DLC3.
- Turn the ignition switch ON and push the intelligent
tester main switch ON.
- Select the item KEY SW in the DATA LIST and read its
value displayed on the intelligent tester.
Transponder key ECU
6 PROBLEM SYMPTOMS TABLE
- If the fault is not listed on the problem symptoms table,
proceed to A.
- If the fault is listed on the problem symptoms table,
proceed to B
7 OVERALL ANALYSIS AND TROUBLESHOOTING
- Inspection with the intelligent tester (ECU DATA
MONITOR).
- Inspection with the intelligent tester (ACTIVE TEST).
- Terminals of ECU
8 ADJUST, REPAIR OR REPLACE
9 CONFIRMATION TEST
END
PARTS LOCATION
SYSTEM DESCRIPTION
The engine immobiliser system has been designed to prevent
the vehicle from being stolen. This system uses a
transponder key ECU that stores the key code of t ...
1. DESCRIPTION OF CODE REGISTRATION
HINT:
The key has 2 codes: The key code (immobiliser code)
and the wireless code. Both of these codes need to be
registered. Refer to page for the wireless code ...
Other materials:
Removal
1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
HINT:
See page EM-26
2. SECURE ENGINE (See page EM-37)
3. REMOVE GENERATOR ASSEMBLY (See page CH-17)
4. REMOVE COMPRESSOR AND MAGNETIC CLUTCH
(See page AC-227)
5. REMOVE NO. 1 ENGINE FRONT MOUNTING
BRACKET LH (See page EM-42)
6. REMOVE NO. 2 IDLER PU ...
Data list / active test
1. DATA LIST
HINT:
Using the intelligent tester to read the DATA LIST allows
the values or states of switches, sensors, actuators and
other items to be read without removing any parts. This
non-intrusive inspection can be very useful because
intermittent conditions or signals may be discovered ...
Towing with a wheel-lift type truck
From the front (2WD models)
Release the parking brake.
From the front (AWD models)
Use a towing dolly under the rear
wheels.
From the rear
Use a towing dolly under the front
wheels. ...