1 VEHICLE BROUGHT TO WORKSHOP
2 CUSTOMER PROBLEM ANALYSIS
3 BASIC INSPECTION
Standard voltage: 11 to 14 V
4 PROBLEM SYMPTOMS TABLE
5 CIRCUIT INSPECTION AND PART INSPECTION
6 IDENTIFICATION OF PROBLEM
7 REPAIR OR REPLACE
8 CONFIRMATION TEST
END
Vehicle interior
Items
Check points
Accelerator pedal
The accelerator pedal should move
smoothly (without uneven pedal effort or
catching).
Automatic transaxle “Park”
mechanism
When parked on a slope with the shift
lever in P, is ...
Removal
1. REMOVE ROOF DRIP SIDE FINISH MOULDING
Put protective tape around the roof drip side finish
moulding.
Using a remover for the roof moulding, disengage of
the clips both in the front and rear ends of the roof
drip side finish moulding and then remove the roof
drip side finish moul ...
Adjustment
HINT:
On the RH side, use the same procedures as on the LH
side.
Since a centering bolt is used as a door hinge mounting
bolt on the body side and the door side, the door can not
be adjusted with it on. Substitute a bolt with a washer for
the centering bolt.
1. INSPECT FRONT DOOR PA ...