HINT: The intelligent tester can be used in steps 2, 3, 4, 6 and 9.
1 VEHICLE BROUGHT TO WORKSHOP
2 CONNECT INTELLIGENT TESTER TO DLC3
HINT: If the display indicates a communication fault in the tester, inspect the DLC3.
3 CHECK DTC AND FREEZE FRAME DATA
HINT: Record or print the DTCs and freeze frame data, if necessary.
4 CLEAR DTC AND FREEZE FRAME DATA
5 CONDUCT VISUAL INSPECTION
6 SET CHECK MODE DIAGNOSIS
7 CONFIRM PROBLEM SYMPTOMS
HINT: If the engine does not start, perform steps 9 and 11 first.
Result
8 SIMULATE SYMPTOMS
9 CHECK FOR DTCS
Result
10 REFER TO DTC CHART
HINT: Refer to the DTC chart
GO TO STEP 13
11 CONDUCT BASIC INSPECTION
HINT: Refer to "BASIC INSPECTION".
Result
12 REFER TO PROBLEM SYMPTOMS TABLE
HINT: Refer to "PROBLEM SYMPTOMS TABLE".
Result
13 CHECK ECM POWER SOURCE CIRCUIT
HINT: Refer to "ECM POWER SOURCE CIRCUIT"
14 CONDUCT CIRCUIT INSPECTION
Result
15 CHECK FOR INTERMITTENT PROBLEMS
HINT: Refer to "CHECK FOR INTERMITTENT PROBLEMS"
GO TO STEP 17
16 CONDUCT PARTS INSPECTION
17 IDENTIFY PROBLEM
18 ADJUST AND/OR REPAIR
19 CONDUCT CONFIRMATION TEST
END
Short to GND in Driver Side Squib Circuit
DTC B0102/11 Short to GND in Driver Side Squib Circuit
DESCRIPTION
The driver side squib circuit consists of the center airbag sensor assembly,
the spiral cable and the
steering pad.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0102/11 is recorded when ...
Inspection
1. V
(a) Inspect VSV operation.
(1) Using an ohmmeter, measure the resistance
according to the value(s) in the table below.V
Standard resistance
If the result is not as specified, replace the
vsv.
(B) inspect the vsv for ground.
(1) Using an ohmmeter, measure the resistance
accordin ...
Replying to a message
Display the message inbox screen.
Select the desired message from the list.
Select “Quick Message”.
Select the desired message.
Select “Send”.
If an error message is displayed, follow the guidance on the screen to try
again.
Editing quick reply message
Select “Quick ...