Toyota Sienna Service Manual: How to proceed with troubleshooting
HINT: *: Use the intelligent tester.
1 VEHICLE BROUGHT TO WORKSHOP
2 CUSTOMER PROBLEM ANALYSIS
- Confirm problem symptoms
3 CHECK MULTIPLEX COMMUNICATION SYSTEM*
- Check if the multiplex communication system DTC is output.
HINT: The center airbag sensor assembly of this system is connected to the multiplex communication system.
Therefore, before starting troubleshooting, make sure to check that there is no trouble in the multiplex communication system.
Result:
4 CHECK CAN COMMUNICATION SYSTEM
- Use the intelligent tester to check if the CAN communication system is functioning normally .
HINT: The ECM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
Result:
5 SRS WARNING LIGHT CHECK
- Proceed to Diagnosis System
6 CHECK FOR DTC*
- Proceed to DTC Check / Clear.
Result:
7 DIAGNOSTIC TROUBLE CODE CHART
- Proceed to Diagnostic Trouble Code Chart
8 SYMPTOM SIMULATION
- Proceed to Diagnosis System
9 PROBLEM SYMPTOMS TABLE
- Proceed to Problem Symptoms Table
10 CIRCUIT INSPECTION*
11 IDENTIFICATION OF PROBLEM
12 REPAIR OR REPLACEMENT
13 CONFIRMATION TEST
END
System description
1. GENERAL
In conjunction with impact absorbing structure for a
frontal collision, the SRS (Supplemental Restraint
System) driver airbag and front passenger airbag
were designed to sup ...
Problem symptoms table
HINT:
Proceed to the troubleshooting for each circuit in the table
below.
AIRBAG SYSTEM
Symptom
Suspected Area
The SRS warning light goes off after the primary
check, ...
Other materials:
Problem symptoms table
POWER BACK DOOR SYSTEM
Symptom
Suspected Area
Power back door does not operate when switch* is
pressed (* Switch indicates the satellite switch for
power back door)
ECU-B fuse
Power back door main switch
Satellite switch
Power back door tou ...
Open in Front Passenger Side Squib Circuit
DTC B0106/54 Open in Front Passenger Side Squib Circuit
DESCRIPTION
The front passenger side squib circuit consists of the center airbag sensor
assembly and the front
passenger airbag assembly.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0106/54 is rec ...
Rear Airbag Sensor LH Circuit Malfunction
DTC B1155/39 Rear Airbag Sensor LH Circuit Malfunction
DESCRIPTION
The rear airbag sensor LH circuit consists of the center airbag sensor
assembly and rear airbag sensor
LH.
If the center airbag sensor assembly receives signals from the rear airbag
sensor LH, it judges whether or
not the ...
