Toyota Sienna Service Manual: How to proceed with troubleshooting
HINT:
- Use this procedure to troubleshoot the front power seat control system.
- The intelligent tester should be used in steps 3 and 5.
1 VEHICLE BROUGHT TO WORKSHOP
2 CUSTOMER PROBLEM ANALYSIS CHECK AND PROBLEM SYMPTOM CHECK
3 CHECK COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)
- Use the intelligent tester to check for normal function of the multiplex communication system.
- (Position control ECU and switch assembly (power seat control switch and ECU) not connected, communication line malfunctioning) If no code is output, proceed to A.
- (Position control ECU and switch assembly (power seat control switch and ECU) not connected, communication line malfunctioning) If any code is output, proceed to B.
4 PROBLEM SYMPTOMS TABLE
- If the fault is not listed on the problem symptoms table, proceed to A.
- If the fault is listed on the problem symptoms table, proceed to B.
5 OVERALL ANALYSIS AND TROUBLESHOOTING
- DATA LIST/ACTIVE TEST.
- Inspection with the intelligent tester (DATA LIST).
- Inspection with the intelligent tester (ACTIVE TEST).
- Terminals of ECU.
- Inspection.
6 ADJUST, REPAIR OR REPLACE
7 CONFIRMATION TEST
END
System description
1. GENERAL DESCRIPTION
The power seat control system is equipped with the
following function:
The front seats are equipped with electric
adjuster slide, reclining, lifter, fr ...
Problem symptoms table
HINT:
Inspect the fuse and relay before confirming the suspected
areas in the table below.
Inspect each suspected area in numerical order for the
corresponding symptom.
If the ...
Other materials:
Adjustment
HINT:
On the RH side, use the same procedures as on the LH side.
1. INSPECT SLIDE DOOR PANEL SUB-ASSEMBLY LH
Check that the clearance is within the standard
range.
Standard
2. ADJUST SLIDE DOOR PANEL SUB-ASSEMBLY LH
Using the SST, horizontally and vertically adjust the
...
Reassembly
1. INSTALL GENERATOR ROTOR ASSEMBLY
(a) Place the drive end frame on the clutch pulley.
(b) Install the generator rotor assembly to the drive end
frame.
(c) Place a new generator washer on the generator
rotor.
2. INSTALL GENERATOR COIL ASSEMBLY
(a) Using a deep socket wrench (21 ...
Short to B+ in Curtain Shield Squib LH Circuit
DTC B1168/86 Short to B+ in Curtain Shield Squib LH Circuit
DESCRIPTION
The curtain shield squib LH circuit consists of the center airbag sensor
assembly and the curtain shield
airbag assembly LH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B1168/86 is ...
