Toyota Sienna Service Manual: How to proceed with troubleshooting
HINT: Troubleshoot in accordance with the procedures on the following pages.
1 VEHICLE BROUGHT TO WORKSHOP
2 CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK
3 INSPECT COMMUNICATION FUNCTION OF LARGE-SCALE MULTIPLEX COMMUNICATION SYSTEM (BEAN)
- Use the intelligent tester to check for normal function of the multiplex communication system.
- (ECU unconnected, communication line malfunctioning) Without code outputs, proceed to A.
- (ECU unconnected, communication line malfunctioning) With code outputs, proceed to B.
4 DTC CHECK
- Check for a diagnostic trouble code.
- Without code outputs, proceed to A.
- With code outputs, proceed to B.
5 PROBLEM SYMPTOMS TABLE
- When problem is not listed on problem symptoms table, proceed to A.
- When problem is listed on problem symptoms table, proceed to B.
6 PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM
- Data List / Active Test.
- Operation check.
- Inspection.
- Terminals of ECU
7 ADJUST, REPAIR OR REPLACE
8 RESET POWER SLIDE DOOR SYSTEM
9 CONFIRMATION TEST
END
Power slide door system
PARTS LOCATION
...
Operation check
NOTICE:
Inspection should be started after conforming that the
items listed in the "CUSTOMIZE PARAMETER" for the
power slide door system have defaulted to the initial
settings.
1. CHECK ...
Other materials:
System description
1. POWER MIRROR CONTROL SYSTEM DESCRIPTION
This system has these functions: automatic glare-resistant
electrochromic (EC) mirror, electrical remote control type
mirror, memory function, foot light function, and rear
window defogger-linked mirror defogger.
2. FUNCTION OF MAIN COMPONENT
...
Disassembly
1. REMOVE AIR REFINER ELEMENT
(a) Release the 2 claw fittings and remove the air filter
sub-assembly.
(b) Remove the air refiner element from the air filter
cover plate.
2. REMOVE COOLING UNIT DAMPER SERVO SUBASSEMBLY
(a) Remove the 3 screws and the cooling unit damper
servo sub-a ...
Oxygen (A/F) Sensor Pumping Current Circuit
HINT:
Although the DTC titles say oxygen sensor, these DTCs relate to the
Air-Fuel Ratio (A/F) sensor.
Sensor 1 refers to the sensor mounted in front of the Three-Way
Catalytic Converter (TWC) and
located near the engine assembly.
DESCRIPTION
Refer to DTC P2195 (See page ES-355 ...
