Toyota Sienna Service Manual: How to proceed with troubleshooting
HINT: Troubleshoot in accordance with the procedures on the following pages.
1 VEHICLE BROUGHT TO WORKSHOP
2 DTC CHECK
- Check for DTCs and make a note of the code that is output (See page MP-14).
- Delete the DTC.
- Check if the DTC is output once again when the problem symptom is simulated based on the noted code.
- When no code is output (symptom check and simulation are possible), proceed to A.
- When a code is output, proceed to B.
3 PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM
- Terminals of ECU
4 ADJUST, REPAIR OR REPLACE
END
System description
1. MULTIPLEX COMMUNICATION SYSTEM (BEAN)
The BEAN communication line is used to control the
combination meter, the A/C amplifier, the airbag
sensor assembly, the multiplex network body ECU,
...
Terminals of ECU
1. MULTIPLEX NETWORK GATEWAY ECU
Disconnect the G4 ECU connector.
Measure the voltage between the specified
terminals on the wire harness side connector.
If the result is not as ...
Other materials:
Power seat switch
Inspection
1. INSPECT FRONT POWER SEAT SWITCH
Inspect the driver side power seat switch.
Measure the resistance according to the
value(s) in the table below.
Standard resistance:
Slide switch
Front vertical switch
Lifter switch
Reclining switch
If the res ...
Throttle Actuator Control System
DTC P2111 Throttle Actuator Control System - Stuck Open
DTC P2112 Throttle Actuator Control System - Stuck
Closed
DESCRIPTION
The throttle actuator is operated by the ECM, and opens and closes the
throttle valve using the gears.
The opening angle of the throttle valve is detected by the Thr ...
Driving in vehicle-to-vehicle distance control mode
This mode employs a radar sensor to detect the presence of vehicles
up to approximately 400 ft. (120 m) ahead, determines the current
vehicle-to-vehicle following distance, and operates to maintain a suitable
following distance from the vehicle ahead.
Note that vehicle-to-vehicle distance will ...
