NOTICE: DTCs for the CAN communication system are as follows: U0073, U0100, U0122, U0123, U0124, U0126 and U1101.
HINT: If U0235 or U1102 is output alone, the CAN communication is normal
1 CHECK AND CLEAR DTCS
HINT:
2 CHECK FOR INSTALLED SYSTEMS (ECUS & SENSORS) THAT ADOPT CAN COMMUNICATION)
3 CHECK WITH INTELLIGENT TESTER
Result
Result |
Proceed to |
All ECUs and sensors connected to the CAN communication system are
not displayed on the
screen.
(Open in CAN bus main wire or short in CAN bus wire or DLC3 branch wire malfunction) |
A |
One of the ECUs and sensors connected to the CAN communication
system is not displayed on the
screen.
(Open in ECU or sensor branch wires, or communication interrupted) |
B |
Some of the ECUs and sensors connected to the CAN communication
system are not displayed on
the screen. During this check, some ECUs and sensors repeatedly appear
and disappear from the
screen.
(Open in one side of ECU or sensor branch wires) |
C |
All ECUs and sensors connected to the CAN communication system are
displayed on the screen.
(CAN bus circuit is currently normal) |
D |
NOTICE: Non-installed ECUs or sensors will not be displayed.
Do not mistake them for being in the communication stop mode.
HINT: The ECUs and sensors that repeatedly appear and disappear from the screen during this check are considered normal. (The response to the intelligent tester and the tester display are affected by signals output from other ECUs which have an open circuit in either of their CAN branch wires.)
4 CHECK CAN BUS WIRE
HINT: If the area where an open or short is occurring in a CAN bus wire can be determined, refer to the "PROBLEM SYMPTOMS TABLE"
5 DTC COMBINATION TABLE
6 CIRCUIT INSPECTION
7 IDENTIFICATION OF PROBLEM
8 REPAIR OR REPLACE
9 CONFIRMATION TEST
END
Air Inlet Damper Position Sensor Circuit
DESCRIPTION
This sensor detects the position of the air inlet control servo motor and
sends the appropriate signals to
the A/C amplifier. The position sensor is built in the air inlet control servo
motor.
The position sensor's resistance changes as the air inlet control servo motor
ar ...
Cargo net hooks
Raise the hook to use.
Pattern 1
Pattern 2
NOTICE
To prevent damage to the cargo net hooks, avoid hanging things other
than
a cargo net on them.
Storage box (if equipped)
Engage the latch buckle. ...
Disassembly
HINT:
Overhaul the RH side by the same procedures as these of
the LH side.
1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER
ASSEMBLY LH
HINT:
Do not disconnect the flexible hose from the brake
caliper.
3. REMOVE REAR DISC
(a) Release the parking brake, and remove the rear
disc.
H ...