Toyota RAV4 manuals

Toyota Sienna Service Manual: How to troubleshoot ecu controlled systems

Toyota Sienna Service Manual / Introduction / How to troubleshoot ecu controlled systems

Vehicle lift and support locations
1. NOTICE ABOUT VEHICLE CONDITION WHEN JACKING UP VEHICLE (a) The vehicle must be unloaded before jacking up/ lifting up the vehicle. Never jack up/lift up a heavily loaded vehicle. (b) When re ...

General information
A large number of ECU controlled systems are used in the SIENNA. In general, ECU controlled systems are considered to be very intricate, requiring a high level of technical knowledge to troubleshoo ...

Other materials:

Checking monitor status
The purpose of the monitor result (mode 06) is to allow access to the results for on-board diagnostic monitoring tests of specific components/systems that are not continuously monitored. Examples are catalyst, evaporative emission (EVAP) and thermostat. The monitor result allows the OBD II sc ...

Short to B+ in Driver Side Squib Circuit
DTC B0103/12 Short to B+ in Driver Side Squib Circuit DESCRIPTION The driver side squib circuit consists of the center airbag sensor assembly, the spiral cable and the steering pad. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B0103/12 is recorded when a ...

Fuel Receiver Gauge Malfunction
DESCRIPTION The meter CPU uses the fuel sender gauge assembly to determine the level of the fuel in the fuel tank. The resistance of the fuel sender gauge will vary between approximately 15 Ω with the float at the full position, and 410 Ω with the float at the empty position. The ...

В© 2011-2024 Copyright www.tsienna.net