Toyota Sienna 2010-2024 Owners Manual: If you have a flat tire (vehicles with a compact spare tire)
Your vehicle is equipped with a spare tire. The flat tire can be replaced with the spare tire.
For details about tires:
| WARNING If you have a flat tire Do not continue driving with a flat tire. Driving even a short distance with a flat tire can damage the tire and the wheel beyond repair, which could result in an accident. |
Before jacking up the vehicle
- Stop the vehicle on a hard, flat surface.
- Set the parking brake.
- Shift the shift lever to P.
- Stop the engine.
- Turn on the emergency flashers.
- Location of the spare tire, jack and tools
- Taking out the jack and tools
- Taking out the spare tire
- Replacing a flat tire
- Installing the spare tire
- Stowing the flat tire
- Stowing the spare tire
If you have a flat tire
(vehicles with
run-flat tires)
Your vehicle is not equipped with a spare tire, but instead you
can continue driving the vehicle with run-flat tires even if any
tire goes flat.
In this case, slow down and drive with extra cauti ...
Location of the spare tire, jack and tools
Spare tire
Jack handle
Tire bag
Jack
Wheel nut wrench
Adapter socket
Tire strap
WARNINGUsing the tire jack
Observe the following precautions.
Improper use of the t ...
Other materials:
Oxygen (A/F) Sensor Pumping Current Circuit
HINT:
Although the DTC titles say oxygen sensor, these DTCs relate to the
Air-Fuel Ratio (A/F) sensor.
Sensor 1 refers to the sensor mounted in front of the Three-Way
Catalytic Converter (TWC) and
located near the engine assembly.
DESCRIPTION
Refer to DTC P2195 (See page ES-355 ...
VSC Warning Light Remains ON
DESCRIPTION
The skid control ECU is connected to the combination meter via CAN and
multiplex communications.
If the skid control ECU stores DTCs to shut down TRAC and VSC operation, the VSC
warning light comes
on in the combination meter.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
...
Installation
1. INSTALL DISTANCE CONTROL ECU ASSEMBLY
Using a torque wrench, install the bolt.
Torque: 5 N*m (51 kgf*cm, 44 in.*lbf)
NOTICE:
Do not install the dropped or shocked distance
control ECU assembly.
2. INITIALIZE DISTANCE CONTROL ECU
NOTICE:
After replacing the distance control ECU ...
