Toyota RAV4 manuals

Toyota Sienna 2010-2024 Owners Manual: If your vehicle has to be stopped in an emergency

Toyota Sienna 2010-2024 Owners Manual / When trouble arises / Essential information / If your vehicle has to be stopped in an emergency

Only in an emergency, such as if it becomes impossible to stop the vehicle in the normal way, stop the vehicle using the following procedure:

  1. Steadily step on the brake pedal with both feet and firmly depress it.

    Do not pump the brake pedal repeatedly as this will increase the effort required to slow the vehicle.

  2. Shift the shift lever to N.
  1. After slowing down, stop the vehicle in a safe place by the road.
  2. Stop the engine.
  1. Keep depressing the brake pedal with both feet to reduce vehicle speed as much as possible.
  2. Vehicles without a smart key system: Stop the engine by turning the engine switch to the “ACC” position.

Toyota Sienna. If your vehicle has to be stopped in an emergency


Vehicles with a smart key system: To stop the engine, press and hold the engine switch for 2 consecutive seconds or more, or press it briefly 3 times or more in succession.

Toyota Sienna. If your vehicle has to be stopped in an emergency


  1. Stop the vehicle in a safe place by the road.
WARNING

If the engine has to be turned off while driving

  • Power assist for the brakes and steering wheel will be lost, making the brake pedal harder to depress and the steering wheel heavier to turn.

    Decelerate as much as possible before turning off the engine.

  • Vehicles without a smart key system: Never attempt to remove the key, as doing so will lock the steering wheel
Emergency flashers
The emergency flashers are used to warn other drivers when the vehicle has to be stopped in the road due to a breakdown, etc. Press the switch. All the turn signal lights will flash. To tu ...

Steps to take in an emergency
...

Other materials:

Front floor footrest
COMPONENTS Removal 1. REMOVE FRONT FLOOR FOOTREST Using a screwdriver, disengage the 2 clips and remove the footrest. HINT: Tape the screwdriver tip before use. Disengage the clips and then remove the 2 clips from the footrest. INSTALLATION 1. INSTALL FRONT FLOOR FOOTREST ...

Installation with LATCH system (second seat)
Fold the seatback while pulling the lever and move to the rearmost recline position. Widen the gap between the seat cushion and seatback slightly. Type A Latch the hooks of the lower straps onto the LATCH anchors. If the child restraint has a top tether strap, the ...

Installation
1. INSTALL TIRE PRESSURE WARNING VALVE AND TRANSMITTER (a) Insert the tire pressure warning valve and transmitter into the valve installation hole. Insert it from the inside of the rim so that the printed surface can be seen. NOTICE: Check that there is no visible deformation, damage, ...

© 2011-2024 Copyright www.tsienna.net