1. ZERO POINT CALIBRATION
NOTICE: Make sure that the front passenger seat is not occupied before performing the operation. HINT: Perform the zero point calibration and sensitivity check if any of the following conditions occur.
HINT: Make sure that zero point calibration has finished normally, and then perform the sensitivity check.
HINT: Refer to the intelligent tester operator's manual for further details
OK: "COMPLETE" is displayed.
Standard value: -3.2 to 3.2 kg (-7 to 7 lb)
Standard value: 27 to 33 kg (59.52 to 72.75 lb)
HINT:
Problem symptoms table
HINT: Proceed to the troubleshooting for each circuit in the table below.
Occupant Classification System
Symptom |
Suspected area |
The front passenger seat condition differs from the indication by the passenger airbag ON/OFF indicator (DTC is not output). | Trouble in Passenger Airbag ON/OFF Indicator |
Handling of hose clamps
HANDLING OF HOSE CLAMPS
(a) Before removing the hose, check the clamp position
so that it can be reinstalled in the same position.
(b) Replace any deformed or dented clamps with new
ones.
(c) When reusing a hose, attach the clamp on the
clamp track portion of the hose.
(d) For a s ...
Problem symptoms table
WINDOW DEFOGGER SYSTEM
Symptom
Suspected area
w/ Deicer: Front window deicer does not operate.
(indicator light ON)
FR DEF fuse
Front window deicer relay
Front window deicer wire
Wire harness
w/ deicer: Front window deicer ...
Open in Front Passenger Side Squib 2nd Step
Circuit
DTC B1186/58 Open in Front Passenger Side Squib 2nd Step
Circuit
DESCRIPTION
The front passenger side squib 2nd step circuit consists of the center airbag
sensor assembly and the
front passenger airbag assembly.
The circuit instructs the SRS to deploy when deployment conditions are met.
...