Toyota Sienna Service Manual: Initialization

Toyota Sienna Service Manual / Engine hood / door / Back door closer system / Initialization

1. RESET

When the battery is reconnected: The back door is locked and therefore cannot be opened. Therefore, it is necessary to unlock the back door using the door control switch or transmitter switch.
Reset the power back door system: The power back door ECU records the fully open position and the fully closed position of the power back door in its memory and the power back door fully opens and closes based on this memory. The power back door cannot operate without this memory. In the case where the battery has been removed, manually close the back door fully to reset the power back door system. However, if the battery is removed / installed when the back door is fully open, the power back door operates normally, thus the resetting the system is unnecessary

PROBLEM SYMPTOMS TABLE

BACK DOOR CLOSER SYSTEM

Symptom	Suspected area
Back door closer does not operate	Back door lock assembly Power back door ECU Wire harness

How to proceed with troubleshooting

HINT: Troubleshoot in accordance with the procedures on the following pages 1 VEHICLE BROUGHT TO WORKSHOP 2 CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK 3 INSPECT COMMUNICATION FUNCTION OF L ...

Terminals of ECU

1. CHECK POWER BACK DOOR ECU Disconnect the P13 and P14 ECU connectors, and check the voltage and resistance of each terminal of the wire harness side connectors If the result is no ...

Other materials:

Open in Side Squib LH Circuit
DTC B0116/48 Open in Side Squib LH Circuit DESCRIPTION The side squib LH circuit consists of the center airbag sensor assembly and the front seat side assembly LH. This circuit instructs the SRS to deploy when deployment conditions are met. DTC B0116/48 is recorded when an open circuit is ...

Removal
1. REMOVE REAR WHEEL 2. REMOVE EXHAUST PIPE ASSEMBLY HINT: Perform this procedure only when removing the RH side. (See page EX-8) 3. REMOVE REAR SPEED SENSOR LH HINT: (See page DS-21) 4. REMOVE REAR AXLE SHAFT NUT LH HINT: (See page DS-21) 5. REMOVE REAR DRIVE SHAFT ASSEMBLY LH HINT: ...

Open in Front Pretensioner Squib RH Circuit
DTC B0131/64 Open in Front Pretensioner Squib RH Circuit DESCRIPTION The front pretensioner squib RH circuit consists of the center airbag sensor assembly and the front seat outer belt assembly RH. This circuit instructs the SRS to deploy when deployment conditions are met. DTC B0131/64 i ...