1. RESET SLIDING ROOF MOTOR
Then release the switch and leave it untouched for 10 seconds or more.
HINT: If the battery terminal is disconnected or after the jam protection function has operated, the sliding roof ECU may not detect a position of the roof glass. If the AUTO operation function is still disabled even if the sliding roof motor has been reset, the Hall IC (built in the sliding roof motor assembly) for detecting the roof glass position may be malfunctioning.
Rear Air Outlet Damper Control Servo Motor Circuit
DESCRIPTION
This circuit turns the servo motor and changes each damper position by
receiving the signals from the A/
C amplifier.
The rear air outlet damper servo motor switches the air outlet mode by rotating
(normal, reverse) with
electrical power from the A/C amplifier.
WIRING DIAGRAM
...
Changing the rear setting
Adjusting the temperature setting
Press the “REAR” button (indicator and rear temperature on the
display on).
Turn the “REAR TEMP” dial clockwise to increase the temperature
and counterclockwise to decrease the temperature.
The air conditioning system switches between individual ...
EVAP System
RELATED DTCS
If any EVAP system DTCs are set, the malfunctioning area can be determined
using the table below.
NOTICE:
If the 0.02 inch reference pressure difference between the first and second
checks is greater than
the specification, the DTCs corresponding to the reference pressur ...