1. RESET MEMORY
NOTICE:
|
HINT:
The ECM memorizes the condition that the ECT controls the automatic transaxle assembly and engine assembly according to those characteristics. Therefore, when the automatic transaxle assembly, engine assembly, or ECM has been replaced, it is necessary to reset the memory so that the ECM can memorize the new information.
Reset procedure is as follows.
(a) Turn the engine switch off.
(b) Connect the intelligent tester together with the CAN VIM (controller area network vehicle interface module) to the DLC3.
(c) Turn the ignition switch to the ON position and push the intelligent tester main switch on.
(d) Select the item "DIAGNOSIS / ENHANCED OBD II".
(e) Perform the reset memory procedure from the ENGINE menu.
CAUTION: After performing the RESET MEMORY, be sure to perform the ROAD TEST (See page AX-9) described earlier. |
HINT: The ECM is learned by performing the ROAD TEST.
(1) Tester menu flow:
Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable
to prevent the airbag working.
2. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Disengage the 4 clips and remove the instrument
cluster finish panel sub-assembly.
...
Power back door system
PARTS LOCATION
...
Radio and Navigation Assembly Communication Error
INSPECTION PROCEDURE
1 IDENTIFY THE COMPONENT SHOWN BY THE SUB-CODE
Enter the diagnostic mode.
Press the "LAN Mon" switch to change to "LAN Monitor"
mode.
Identify the component shown by the sub-code.
HINT:
"110 (multi-display)" i ...