Toyota Sienna Service Manual: Inner rear view mirror
COMPONENTS
REMOVAL
1. REMOVE INNER REAR VIEW MIRROR ASSEMBLY
- w/ EC mirror: Remove the inner rear view mirror cover.
- w/ EC mirror: Disconnect the connector.
- Remove the screw.
- Remove the inner rear view mirror assembly as shown in the illustration.
INSPECTION
1. INSPECT INNER REAR VIEW MIRROR ASSEMBLY
- Inspect operation of the electrochromic inner mirror.
- Connect the positive (+) lead from the battery to terminal 1 and connect the negative (-) lead to terminal 2.
- Attach black colored tape to the forward sensor to prevent it from sensing.
- Light up the mirror with an electric light and check that the mirror surface changes from bright to dark.
Standard: Mirror surface changes from bright to dark
If the result is not as specified, replace the mirror assembly.
INSTALLATION
1. INSTALL INNER REAR VIEW MIRROR ASSEMBLY
Power mirror control system (w/o Memory)
PARTS LOCATION
Problem symptoms table
POWER MIRROR CONTROL SYSTEM
Symptom
Suspected area
Mirror does not operate
Outer mirror switch assembly
Outer r ...
Outer rear view mirror
COMPONENTS
...
Other materials:
Throttle Actuator Control Motor Circuit
DESCRIPTION
The throttle actuator is operated by the ECM and opens and closes the
throttle valve using gears.
The opening angle of the throttle valve is detected by the Throttle Position
(TP) sensor, which is mounted
on the throttle body. The TP sensor provides feedback to the ECM. This ...
Installation
1. INSTALL RADIO NO. 2 BRACKET
Install radio No. 2 bracket with the 4 screws.
2. INSTALL RADIO NO. 1 BRACKET
Install radio No. 1 bracket with the 4 screws.
3. INSTALL RADIO RECEIVER
Connect the connector.
Install the radio receiver with the 4 scr ...
Operation check
1. INPUT SIGNAL CHECK
Connect the intelligent tester to the DLC3.
Check the cruise control main switch using the
DATA LIST function in the intelligent tester (ONOFF,
CANCEL, - (COAST)/SET, + (ACCEL)/RES
(RESUME), and MODE).
2. INSPECT MODE SWITCH
Turn the ...
