(a) The general VIN input instructions using the intelligent tester are shown below: (b) The arrow buttons (UP, DOWN, RIGHT and LEFT) and numerical buttons (0 to 9) are used to input the VIN.
(c) Cursor Operation To move the cursor around the tester screen, press the RIGHT and LEFT buttons.
(d) Alphabetical Character Input
(1) Press the UP and DOWN buttons to select the desired alphabetical character.
(e) Numerical Character Input
(1) Press the numerical button corresponding to the number that you want to input.
HINT:
Numerical characters can be selected by using the UP and DOWN buttons.
(f) Correction
(1) When correcting the input character(s), put the cursor onto the character using the RIGHT and LEFT buttons.
(2) Select or input the correct character using the UP and DOWN buttons, or the numerical buttons.
(g) Finishing Input Operation
(1) Make sure that the input VIN matches the vehicle VIN after input.
(2) Press the ENTER button on the tester.
Washer fluid
If any washer does not work or the
warning message appears on the
multi-information display, the
washer tank may be empty. Add
washer fluid.
WARNINGWhen refilling washer fluid
Do not refill washer fluid when the engine is hot or running, as
washer fluid
contains alcohol and ...
Pressing Power Switch does not Turn on System
INSPECTION PROCEDURE
1 CHECK VEHICLE CONDITION
Check that conditions in the cabin are not likely to cause
condensation.
HINT:
This problem occurs when the cabin is humid and the
temperature changes rapidly. This may produce
condensation, resulting in a short circuit.
OK:
Condensation ...
Installation
1. INSTALL SPIRAL CABLE
Check that the front wheels are facing straight
ahead.
Set the turn signal switch to the neutral position.
NOTICE:
If it is not in the neutral position, the pin of the
turn signal switch may snap.
Install the spiral cable.
NOTICE:
When ...