Toyota Sienna Service Manual: Inspection
1. INSPECT SHOCK ABSORBER ASSEMBLY REAR LH
(a) Push down and pull up the shock absorber rod, and check that there is no unusual resistance or unusual operation sound.
If there is any malfunction, replace the shock absorber with a new one.
NOTICE: When disposing of the shock absorber, see DISPOSAL (See page SP-54).
Removal
1. REMOVE REAR WHEEL
2. REMOVE REAR SHOCK ABSORBER CAP LH
(a) Remove the shock absorber head cover.
(b) Remove the shock absorber cap LH.
3. REMOVE SHOCK ABSORBER ASSEMBLY REAR LH
(a) S ...
Installation
1. INSTALL SHOCK ABSORBER ASSEMBLY REAR LH
(a) Install the rear spring bumper No.1 LH to the shock
absorber assembly LH.
(b) Support the rear axle beam assembly with a jack.
(c) Install ...
Other materials:
Front floor footrest
COMPONENTS
Removal
1. REMOVE FRONT FLOOR FOOTREST
Using a screwdriver, disengage the 2 clips and
remove the footrest.
HINT:
Tape the screwdriver tip before use.
Disengage the clips and then remove the 2 clips
from the footrest.
INSTALLATION
1. INSTALL FRONT FLOOR FOOTREST ...
Installation
1. INSTALL TIMING CHAIN CASE OIL SEAL
(a) Using SST, tap in a new oil seal until its surface is
flush with the timing chain case edge.
SST 09223-22010, 09506-35010
NOTICE:
Keep the lip free from foreign matter.
Do not tap on the oil seal at an angle.
Make sure that the oil ...
Short in Front Pretensioner Squib LH Circuit
DTC B0135/73 Short in Front Pretensioner Squib LH Circuit
DESCRIPTION
The front pretensioner squib LH circuit consists of the center airbag sensor
assembly and the front seat
outer belt assembly LH.
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0135/73 ...
