1. INSPECT TIRES
(a) Check the tires for wear and proper inflation pressure.
Cold tire inflation pressure
(b) Using a dial indicator, check the runout of the tires.
Tire runout: 1.4 mm (0.055 in.) or less
2. ROTATE TIRES
HINT: Rotate the tires as shown in the illustration.
3. INSPECT WHEEL BALANCE (for Steel Wheel)
(a) Check and adjust the off-the-car balance.
Imbalance after adjustment: 8.0 g (0.018 lb.) or less.
HINT: If necessary, check and adjust the on-the-car balance.
4. INSPECT WHEEL BALANCE (for Non-steel Wheel)
(a) Check and adjust the off-the-car balance.
Imbalance after adjustment: 8.0 g (0.018 lb.) or less.
NOTICE:
HINT:
5. INSPECT FRONT AXLE HUB BEARING LOOSENESS
HINT: See page AH-5.
6. INSPECT REAR AXLE HUB BEARING LOOSENESS (for 2WD)
HINT: See page AH-16.
7. INSPECT REAR AXLE HUB BEARING LOOSENESS (for 4WD)
HINT: See page AH-19.
8. INSPECT FRONT AXLE HUB RUNOUT
HINT: See page AH-5.
9. INSPECT REAR AXLE HUB RUNOUT (for 2WD)
HINT: See page AH-16.
10. INSPECT REAR AXLE HUB RUNOUT (for 4WD)
HINT: See page AH-19.
Open in ABS Solenoid Relay Circuit
DESCRIPTION
This relay supplies power to each ABS solenoid.
Immediately after the ignition switch is turned to the ON position, the relay
turns on if the solenoid is
determined to be normal as a result of self-diagnosis during initial check.
The relay turns off if an open/short is dete ...
Transfer
SST
RECOMMENDED TOOLS
EQUIPMENT
LUBRICANT
SSM
...
Power outlets
The power outlet can be used for the following components:
12 V: Accessories that run on less than 10 A
120 V AC: Accessories that use less than 100 W
12 V
Open the cover.
Center panel type A
Center panel type B
Luggage compartment
120 V AC (if equipped)
Open the ...