Toyota Sienna Service Manual: Inspection
1. INSPECT REAR SPEED SENSOR
(a) Disconnect the skid control sensor connector.
(b) Measure the resistance between terminals 1 and 2 of the skid control sensor connector.
OK: Resistance: less than 2.2 kΩ
(c) Measure resistance between each of terminals 1 and 2 of the skid control sensor connector and body ground.
OK: Resistance: 1MΩ or higher
Removal
HINT:
Remove the RH by the same procedure as the LH side.
1. REMOVE REAR WHEEL
2. SEPARATE SKID CONTROL SENSOR WIRE
(a) Disconnect the connector from the skid control
sensor.
3. REMOVE REAR ...
Installation
HINT:
Install the RH side by the same procedure as the LH side.
1. INSTALL REAR SPEED SENSOR
(a) Clean the contacting surface of the axle hub and a
new skid control sensor.
NOTICE:
Keep the ...
Other materials:
Customer problem analysis
HINT:
In troubleshooting, confirm that the problem symptoms
have been accurately identified. Preconceptions should be
discarded in order to make an accurate judgment. To
clearly understand what the problem symptoms are, it is
extremely important to ask the customer about the
problem an ...
Canceling and resuming the speed control
Pulling the lever toward you
cancels the cruise control.
The speed setting is also canceled
when the brakes are applied.
Pushing the lever up resumes
the cruise control and returns
vehicle speed to the set speed.
Resuming is available when the vehicle speed is more than approxi ...
Problem symptoms table
HINT:
Proceed to troubleshooting of each circuit in the table below.
1. HEADLIGHT AND TAIL LIGHT SYSTEM
2. AUTOMATIC LIGHT CONTROL SYSTEM
3. LIGHT AUTO TURN OFF SYSTEM
4. FOG LIGHT SYSTEM
5. TURN SIGNAL AND HAZARD WARNING SYSTEM
6. ILLUMINATED ENTRY SYSTEM
7. OTHE ...
