Toyota RAV4 manuals

Toyota Sienna Service Manual: Inspection

1. INSPECT BRAKE CYLINDER AND PISTON

(a) Check the brake cylinder bore and front disc brake piston for rust or scoring.

2. INSPECT PAD LINING THICKNESS

INSPECT PAD LINING THICKNESS

(a) Using a ruler, measure the pad lining thickness.

Standard thickness: 12.0 mm (0.472 in.) Minimum thickness: 1.0 mm (0.039 in.)

3. INSPECT FRONT DISC BRAKE PAD SUPPORT PLATE

(a) Inspect the front disc brake pad support plate (No.

1) and front disc brake pad support plate (No. 2).

Make sure that they have sufficient rebound, no deformation, cracks or wear, and have had all rust and dirt cleaned off

4. INSPECT DISC THICKNESS

INSPECT DISC THICKNESS

(a) Using a micrometer, measure the disc thickness.

Standard thickness: 28.0 mm (1.102 in.) Minimum thickness: 26.0 mm (1.024 in.)

Disassembly
1. REMOVE FRONT DISC BRAKE BUSH DUST BOOT (a) Using soft jaws on the vise, hold the front disc brake cylinder mounting LH in the vise through aluminum plates. (b) Using a screwdriver and ham ...

Reassembly
1. INSTALL FRONT DISC (a) Aligning the matchmarks, install the front disc. HINT: Select the installation position where the disc has the minimum runout. 2. INSPECT DISC RUNOUT (a) Temporaril ...

Other materials:

Noise Occurs
INSPECTION PROCEDURE 1 NOISE CONDITION Check in which direction the noise comes from (front left or right, or rear left or right).  Check in which direction the noise comes from. OK: The location of the noise source can be determined 2 CHECK SPEAKERS Check the installatio ...

IG Power Source Circuit
DESCRIPTION The main power source is supplied to the A/C amplifier when the ignition switch is turned to the ON position. The power source is used for operating the A/C amplifier and servo motor, etc. WIRING DIAGRAM INSPECTION PROCEDURE HINT: Start the engine before inspection. Check ...

Removal
1. Disconnect battery negative terminal 2. Remove instrument cluster finish panel sub-assembly center Hint: (see page ip-9) 3. Remove transmission control cable assembly (a) Remove the nut from the control shaft lever. (b) Disconnect the transmission control cable assembly from the con ...

В© 2011-2024 Copyright www.tsienna.net