Toyota RAV4 manuals

Toyota Sienna Service Manual: Inspection

1. INSPECT FRONT SEAT INNER BELT ASSEMBLY RH

INSPECT FRONT SEAT INNER BELT ASSEMBLY RH

  1.  Release the seat belt (Buckle switch is ON).
  2.  Check the resistance between the terminals.

Standard

If the result is not as specified, replace the inner belt assembly.

  1.  Inspect the buckle switch.

INSPECT FRONT SEAT INNER BELT ASSEMBLY RH

  1.  Fasten the seat belt (Buckle switch is OFF).
  2.  Check the resistance between the terminals.

Standard

  1. Inspect the circuit for the airbag seat position sensor.

INSPECT FRONT SEAT INNER BELT ASSEMBLY RH

  1.  Check the resistance between the terminals.

Standard

If the result is not as specified, replace the seat cushion assembly.

2. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH

 INSPECT FRONT SEAT INNER BELT ASSEMBLY LH

  1.  Inspect the buckle switch.
  1.  Fasten the seat belt (Buckle switch is ON).
  2.  Check the resistance between the terminals.

Standard

  1. Release the seat belt (Buckle switch is OFF).
  2.  Check the resistance between the terminals.

 INSPECT FRONT SEAT INNER BELT ASSEMBLY LH

Standard

If the result is not as specified, replace the inner belt assembly

Removal
1. REMOVE FRONT SEAT INNER BELT ASSEMBLY HINT:  Refer to the instructions for disassembly of the front seat assembly (for flat type).  Refer to the instructions for disassembly of ...

Installation
1. REMOVE FRONT SEAT INNER BELT ASSEMBLY HINT:  Refer to the instructions for reassembly of the front seat assembly (for flat type).  Refer to the instructions for reassembly of th ...

Other materials:

Short to GND in Front Passenger Side Squib Circuit
DTC B0107/51 Short to GND in Front Passenger Side Squib Circuit DESCRIPTION The front passenger side squib circuit consists of the center airbag sensor assembly and the front passenger airbag assembly. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B0107/ ...

Sound setting
Display the “Phone/Message Settings” screen. Select “Sound Settings” on the “Phone/Message Settings” screen. Set the desired ringtone. Adjust the ringtone volume. Adjust the message readout volume. Set the desired incoming SMS/MMS tone. Adjust the incoming SMS ...

Removal
HINT:  Use the same procedures for the RH side and LH side.  The procedures listed below are for the LH side. 1. PRECAUTION CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing. 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: Wait for 90 se ...

© 2011-2024 Copyright www.tsienna.net