Toyota Sienna Service Manual: Inspection
1. INSPECT SEAT HEATER SWITCH LH
- Measure the resistance of the seat heater switch when the switch is operated.
Resistance
If the result is not as specified, replace the switch.
HINT: As the dial is being turned, the resistance changes gradually.
- Push the seat heater switch ON and check that the
seat heater switch indicator illuminates when the
switch is operated.
OK
If the result is not as specified, replace the switch.
- Check the seat heater switch illumination.
OK
If the result is not as specified, replace the seat heater switch or bulb.
2. INSPECT SEAT HEATER SWITCH RH
- Measure the resistance of the seat heater switch when the switch is operated.
Resistance
If the result is not as specified, replace the switch.
HINT: As the dial is being turned, the resistance changes gradually.
- Push the seat heater switch ON and check that the seat heater switch indicator illuminates when the switch is operated.
OK
If the result is not as specified, replace the switch.
- Check the seat heater switch illumination.
OK
If the result is not as specified, replace the seat heater switch or bulb.
3. INSPECT FRONT SEAT BACK HEATER ASSEMBLY LH
- Measure the resistance of the seatback heater.
Resistance
If the result is not as specified, replace the seatback heater assembly.
4. INSPECT FRONT SEAT BACK HEATER ASSEMBLY RH
- Measure the resistance of the seatback heater.
Resistance
If the result is not as specified, replace the seatback heater assembly.
5. INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY LH
- Measure the resistance of the seat cushion heater.
Resistance
If the result is not as specified, replace the seat cushion heater assembly.
6. INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY RH
- Measure the resistance of the seat cushion heater.
Resistance
If the result is not as specified, replace the seat cushion heater assembly.
On-vehicle inspection
1. CHECK SEAT HEATER CONTROL (WIRE HARNESS
SIDE)
Disconnect the connector from the seat heater
control.
Measure the voltage and resistance of each
terminal of the wire harne ...
Front seat assembly (for Flat Type)
COMPONENTS
...
Other materials:
Check mode procedure
1. CHECK MODE (SIGNAL CHECK): DTC CHECK
Connect the intelligent tester to the DLC3.
) Turn the ignition switch to the ON position.
) Select the "SIGNAL CHECK", and proceed
checking using the intelligent tester.
NOTICE:
Select the "SIGNAL CHECK" from the &q ...
Vehicle Speed Signal Circuit between Radio Receiver and Combination
Meter
DESCRIPTION
This circuit is necessary for the ASL (Auto Sound Leveliser) built into the
radio receiver.
Speed signals are received from the combination meter and used for the ASL.
The ASL function automatically adjusts the sound data in order to enable hearing
the clear audio sound
even ...
Master Cylinder Pressure Sensor Malfunction
DTC C1246/46 Master Cylinder Pressure Sensor Malfunction
DESCRIPTION
Master cylinder pressure sensor is connected to the skid control ECU in the
actuator.
INSPECTION PROCEDURE
1 READ VALUE ON INTELLIGENT TESTER (MASTER CYLINDER PRESSURE SENSOR)
(a) Connect the intelligent tester to the DL ...
