Toyota Sienna Service Manual: Inspection
1. INSPECT VENTILATION VALVE
(a) Install a clean hose to the ventilation valve.
(b) Check the ventilation valve operation.
(1) Blow air into the cylinder head side, and check that air passes through easily.
| NOTICE:
Do not suck air through the valve.
Petroleum substances inside the valve are hazardous to your health. |
(2) Blow air into the intake manifold side, and check that air passes through with difficulty.
If the result is not as specified, replace the ventilation valve.
(c) Remove the clean hose from the ventilation valve.
Removal
1. REMOVE V-BANK COVER SUB-ASSEMBLY (See
page EM-28)
2. DISCONNECT VENTILATION HOSE
(a) Disconnect the ventilation hose from the ventilation
valve.
3. REMOVE VENTILATION VALVE
(a) Remove ...
Installation
1. INSTALL VENTILATION VALVE
(a) Install the ventilation valve.
(1) Apply adhesive to 2 or 3 threads.
Adhesive:
Part No. 08833-00070, Three Bond 1324 or
equivalent
(2) Install the vent ...
Other materials:
If the shift lever cannot
be shifted from P
If the shift lever cannot be shifted with your foot on the brake
pedal, there may be a problem with the shift lock system (a system
to prevent accidental operation of the shift lever). Have the
vehicle inspected by your Toyota dealer immediately.
The following steps may be used as an emergency ...
Disassembly
1. REMOVE REAR NO. 2 SEAT COVER BEZEL
Remove the 5 screws.
Disengage the 5 claws and remove the rear No. 2
seat cover bezel.
2. REMOVE REAR SEAT RECLINING COVER LH
Remove the 2 screws.
Disengage the claw and remove the rear seat
reclining cover LH.
...
Folding Motor Circuit
DESCRIPTION
The fold seat control ECU receives a switch operation signal from the fold
seat switch and activates the
folding motor. At this time, the Hall IC (seat cushion position sensor) detects
the actuation signal. The fold
seat control ECU uses signals from the Hall IC (seat cushion posi ...
