Toyota RAV4 manuals

Toyota Sienna Service Manual: Inspection

1. INSPECT LOCK PLATE FOR DAMAGE

 INSPECT LOCK PLATE FOR DAMAGE

(a) Inspect the lock plate for damage.

HINT:

NOTICE: The radiator can only be crimped 3 times. After recrimping 2 times, the radiator core must be replaced.
Disassembly
1. REMOVE RADIATOR WATER INLET (a) Remove the 2 bolts and radiator water inlet. 2. REMOVE DRAIN PLUG (a) Remove the drain plug and air drain plug. (b) Remove the 2 O-rings. 3. REMOVE LOWER ...

Reassembly
1. Install lower radiator tank (a) After checking that there are no foreign objects in the lock plate groove, install a new O-ring without twisting it. HINT: When cleaning the lock plate groo ...

Other materials:

Installation
1. INSTALL ROOF DRIP SIDE FINISH MOULDING When exchanging the clips Remove the tape that remains on the mounting surface of the vehicle body and then clean the surface with white gasoline. Using a heat light, heat up the clip installation surfaces of the vehicle body and moulding. ...

Installation
1. INSTALL FRONT BUMPER ASSEMBLY Push the front bumper onto the front of the vehicle and engage the claws on the left and right sides of the front bumper to install it as shown in the illustration. HINT: Apply protective tape to the bottom part of the front fender to prevent i ...

ECM / PCM Processor
DTC P0606 ECM / PCM Processor DESCRIPTION The ECM continuously monitors its internal processors (CPUs), A/F sensor transistors and heated oxygen sensor (HO2S) transistors. This self-check ensures that the ECM is functioning properly. These are diagnosed by internal "mirroring" of t ...

В© 2011-2024 Copyright www.tsienna.net