Toyota RAV4 manuals

Toyota Sienna Service Manual: Inspection

1. Inspect ignition switch assembly

 Inspect ignition switch assembly

(a) Measure the resistance of the switch.

Standard resistance

If the result is not as specified, replace the switch assembly.

Removal
1. Disconnect cable from negative battery terminal 2. REMOVE STEERING COLUMN COVER LOWER (A) insert the key into the ignition key cylinder and release the steering lock. (B) turn the steeri ...

Installation
1. INSTALL IGNITION SWITCH ASSEMBLY (a) Install the ignition switch with the 2 screws. (b) Install the ignition switch connector. 2. INSTALL STEERING COLUMN COVER LOWER (a) Attach the 4 claw ...

Other materials:

Reassembly
1. INSTALL NO. 1 SEAT CUSHION FRAME SUBASSEMBLY LH  Install the seat cushion frame with the bolt. Torque: Except 7-Passenger RH, M8 bolt 20.6 N*m (210 kgf*cm, 15 ft.*lbf) M10 bolt 41 N*m (418 kgf*cm, 30 ft.*lbf) 2. INSTALL RECLINING CONTROL LINK SUBASSEMBLY LH  Install ...

Rear Clearance Sonar Sensor RH Circuit
DESCRIPTION An ultrasonic sensor consists of a sensor portion that transmits and receives ultrasonic waves and a preamplifier that amplifies them. The ultrasonic sensor outputs the ultrasonic waves and sends the received signals to the clearance warning ECU. WIRING DIAGRAM INSPECTION PR ...

Short to B+ in Rear Curtain Shield Squib RH Circuit
DTC B1633/82 Short to B+ in Rear Curtain Shield Squib RH Circuit DESCRIPTION The rear curtain shield squib RH circuit consists of the center airbag sensor assembly and the curtain shield airbag assembly RH. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B ...

В© 2011-2024 Copyright www.tsienna.net