1. INSPECT PRELOAD
(a) Using SST(s) and a torque wrench, check the initial torque within the backlash range.
SST 09326-20011 Torque: 0.9 to 1.4 N*m (9 to 14 kgf*cm, 8.0 to 12.4 in.*lbf)
HINT: Use a torque wrench with a fulcrum length of 160 mm (6.30 in.).
(b) Using SST(s) and a torque wrench, check the initial torque while the driven pinion is in contact with the ring gear face.
SST 09326-20011 Torque: Preload +0.15 to 0.30 N*m (+1.6 to 3.1 kgf*cm, +1.3 to 2.7 in.*lbf)
HINT: Use a torque wrench with a fulcrum length of 160 mm (6.30 in.).
2. INSPECT DIFFERENTIAL RING GEAR BACKLASH
(a) Set the dial gauge perpendicular to the tooth face of the ring gear, fix the driven pinion and inspect the backlash while moving the gear.
Backlash: 0.10 to 0.15 mm (0.0039 to 0.0059 in.)
NOTICE: Inspect it at 3 points or more on the gear's periphery.
3. INSPECT TOOTH CONTACT BETWEEN RING GEAR AND DRIVE PINION
(a) Apply red lead primer thinly and uniformly to both faces of the ring gear and rotate several times.
NOTICE: Inspect the tooth contact on the ring gear at 4 places or more.
4. INSPECT RUNOUT OF TRANSFER RING GEAR MOUNTING CASE
(a) Using a dial gauge check the transfer ring gear mounting case runout.
Maximum runout: 0.03 mm (0.0012 in.)
Oxygen (A/F) Sensor Heater Control Circuit
Low/ Oxygen (A/F) Sensor Heater Control Circuit
High
DTC P0031 Oxygen (A/F) Sensor Heater Control Circuit
Low (Bank 1 Sensor 1)
DTC P0032 Oxygen (A/F) Sensor Heater Control Circuit
High (Bank 1 Sensor 1)
DTC P0051 Oxygen (A/F) Sensor Heater Control Circuit
Low (Bank 2 Sensor 1)
DTC P0052 Oxygen (A/F) Sensor Heater Control Circuit
High (Bank 2 S ...
Driver Side Seat Belt Warning Light does not Operate
DESCRIPTION
When turning the ignition switch to the ON position, the combination meter
assembly communicates with
the supplemental restraint system by the multiplex communication system. Unless
the driver side seat
belt is fastened, the combination meter assembly will turn on the seat belt
...
Reassembly
1. INSTALL DIFFERENTIAL CASE SUB-ASSEMBLY NO.2
(a) Coat the front differential side gear thrust washer
No.1, front differential planetary ring gear, front
differential pinion No.2, front differential pinion thrust
washer No.2, front differential pinion shaft holder,
front differential pinio ...