1. INSTALL REAR DIFFERENTIAL SIDE GEAR SHAFT BOLT
(a) Install the bolt tightening the nut through the plate washer.
2. INSTALL REAR DRIVE SHAFT ASSEMBLY LH
HINT: (See page DS-26)
3. INSTALL REAR AXLE SHAFT NUT LH
HINT: (See page DS-26)
4. INSTALL REAR SPEED SENSOR LH
HINT: (See page DS-26)
5. INSTALL EXHAUST PIPE ASSEMBLY
HINT: (See page EX-10)
6. INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
7. INSPECT FOR EXHAUST GAS LEAK
8. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
HINT: (See page SP-4)
9. INSPECT ABS SPEED SENSOR SIGNAL
HINT: (See page BC-3)
Idle Control System Malfunction
DESCRIPTION
The idling speed is controlled by the ETCS (Electronic Throttle Control
System). The ETCS is comprised
of: 1) the one valve type throttle body; 2) the throttle actuator, which
operates the throttle valve; 3) the
Throttle Position (TP) sensor, which detects the opening angle of ...
Operating the HomeLink
Press the appropriate HomeLink® button. The HomeLink® indicator
light on the HomeLink® transceiver should turn on.
The HomeLink® continues to send a signal for up to 20 seconds as long as
the button is pressed.
Reprogramming a HomeLink® button
Press and hold the desired HomeLink® button ...
Removal
1. DRAIN BRAKE FLUID
NOTICE:
Wash brake fluid off immediately if it adheres to any
painted surface.
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE AIR CLEANER ASSEMBLY WITH HOSE
4. REMOVE BRAKE ACTUATOR WITH BRACKET
(a) Release the latch of the brake actuator connector to
disconnect t ...