HINT: Install the RH side by same procedure as the LH side.
1. INSTALL REAR SPEED SENSOR
(a) Install the speed sensor rear LH with the bolt.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
NOTICE: Keep the tip of the speed sensor rear LH clean.
(b) Install the sensor harness clamps with the bolts to the body.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) (c) Push in the sensor wire harness with grommet.
NOTICE: When grommet i set to body, pull the grommet, and don't pull the sensor wire.
(d) Connect the speed sensor connector.
2. INSTALL QUARTER TRIM PANEL ASSEMBLY LH
3. INSTALL REAR WHEEL Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
4. CHECK ABS SPEED SENSOR SIGNAL
HINT: See page BC-10.
Installation
1. INSTALL FOG LIGHT ASSEMBLY
Install the fog light assembly with the 2 claws and 2
pins.
2. INSTALL FRONT BUMPER ASSEMBLY
3. CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
4. VEHICLE PREPARATION FOR FOG LIGHT AIMING
5. PREPARATION FOR FOG LIGHT AIMING
6. FOG LIGHT AIMING INSPECT ...
Repair
1. INSTALL HEADLIGHT PROTECTOR RETAINER UPPER
HINT:
If the installation area of the headlight assembly is
damaged, use the supply bracket for low-cost repair.
Ensure that the headlight assembly is not damaged.
Cut off the part shaded in the illustration and sand
smoo ...
Brake Switch
DTC P0504 Brake Switch "A" / "B" Correlation
DTC P0724 Brake Switch "B" Circuit High
DESCRIPTION
The stop light switch is a duplex system that transmits two signals: STP and
ST1-. These two signals are
used by the ECM to monitor whether or not the brake system is ...