Toyota RAV4 manuals

Toyota Sienna Service Manual: Installation

1. INSTALL AIR CONDITIONING BLOWER ASSEMBLY

INSTALL AIR CONDITIONING BLOWER ASSEMBLY

(a) Install the air conditioning blower assembly with the 3 bolts.

Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE: Tighten the bolts in the order shown in the illustration to install the air conditioning blower assembly.

2. INSTALL AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY

(a) Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the air conditioning tube & accessory assembly.

Compressor oil: ND-OIL 8 or equivalent

(b) Install the 2 O-rings on the air conditioning tube & accessory assembly.

(c) Install the air conditioning tube & accessory assembly with the 2 bolts.

Torque: 3.5 N*m (36 kgf*cm, 31 in.*lbf)

 INSTALL AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY

3. ADD ENGINE COOLANT

HINT: See page CO-7.

4. CHARGE REFRIGERANT

SST 07110-58060 (07117-58060, 07117-58070, 07117-58080, 07117-58090, 07117-78050, 07117-88060, 07117-88070, 07117-88080)

HINT: See page AC-172.

5. WARM UP ENGINE

6. INSPECT FOR ENGINE COOLANT LEAK

HINT: See page CO-1.

7. INSPECT REFRIGERANT LEAK

HINT: See page AC-168.

Reassembly
1. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY (a) Install the heater radiator unit sub-assembly to the air conditioning blower assembly. (b) Install the 2 O-rings to the heater water valve as ...

Blower motor
On-vehicle inspection 1. INSPECT BLOWER WITH FAN MOTOR SUBASSEMBLY (a) Connect the positive (+) lead from the battery to terminal 2 and negative (-) to terminal 1, then check that the motor op ...

Other materials:

Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 2. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) (See page EC-38) 3. REMOVE TAIL EXHAUST PIPE ASSEMBLY (a) Remove the 2 bolts. (b) Disconnect the 4 exhaust pipe supports and remove the tail exhaust pipe assembly. (c) Remove the gas ...

Checking monitor status
The purpose of the monitor result (mode 06) is to allow access to the results for on-board diagnostic monitoring tests of specific components/systems that are not continuously monitored. Examples are catalyst, evaporative emission (EVAP) and thermostat. The monitor result allows the OBD II sc ...

Installation
1. INSTALL FRONT SUSPENSION ARM SUBASSEMBLY LOWER NO.1 LH (a) Install the front lower arm bush stopper to the front suspension arm sub-assembly lower No.1 LH. (b) Install the bolt and nut to the rear side of the front suspension arm sub-assembly lower No.1 LH. Torque: 206 N*m (2,100 kgf ...

В© 2011-2024 Copyright www.tsienna.net