Toyota Sienna Service Manual: Installation
1. INSTALL SPIRAL CABLE
- Check that the front wheels are facing straight ahead.
- Set the turn signal switch to the neutral position.
NOTICE: If it is not in the neutral position, the pin of the turn signal switch may snap.
- Install the spiral cable.
NOTICE: When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.
- Connect the connectors to the spiral cable.
NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.
2. INSTALL STEERING COLUMN COVER
- Install the steering column cover with the 2 screws.
3. ADJUST SPIRAL CABLE
- Check that the ignition switch is off.
- Check that the battery negative (-) terminal is disconnected.
CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.
- Rotate the spiral cable counterclockwise slowly by hand until it feels firm.
NOTICE: Do not turn the spiral cable by the airbag wire harness.
- Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
NOTICE: Do not turn the spiral cable by the airbag wire harness. HINT: The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.
4. INSTALL STEERING WHEEL ASSEMBLY
5. INSPECT STEERING WHEEL CENTER POINT
6. INSTALL STEERING PAD
7. INSTALL STEERING WHEEL NO.2 COVER LOWER (25)
8. INSTALL STEERING WHEEL NO.3 COVER LOWER (25)
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. INSPECT STEERING PAD (25)
11. PERFORM INITIALIZATION
- Perform initialization.
HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.
12. INSPECT SRS WARNING LIGHT
- Inspect the SRS warning light
Removal
1. PRECAUTION
CAUTION: Be sure to read "PRECAUTION" thoroughly before
servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting th ...
Front passenger airbag assembly
COMPONENTS
...
Other materials:
Data list / active test
1. DATA LIST
The wireless door lock control data list can be
displayed while the intelligent tester is connected to
the DLC3 with the ignition switch in the ON position.
Follow the prompts on the tester screen to access
the DATA LIST.
BODY:
2. ACTIVE TEST
HINT:
Performing the ACT ...
Installation
1. INSTALL INSTRUMENT PANEL SAFETY PAD SUBASSEMBLY
Using a torque wrench, install the bolt <B>.
Torque: 20 N*m (204 kgf*cm, 14 ft.*lbf)
2. INSTALL SHIFT LEVER ASSEMBLY
Using a torque wrench, install the 4 bolts.
Torque: 21 N*m (214 kgf*cm, 12.6 ft.*lbf)
3. ...
Dtc check / clear
1. DTC CHECK (NORMAL MODE)
NOTICE:
When the diagnostic system is switched from the
normal mode to the check mode, all the DTCs and
freeze frame data recorded in the normal mode will
be erased. So before switching modes, always check
the DTCs and freeze frame data, and note the ...
