HINT:
1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH
Torque: 14 N*m (143 kgf*cm, 10 ft.*lbf)
NOTICE: Do not twist the curtain shield airbag assembly LH when installing it.
NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.
2. INSTALL POWER BACK DOOR UNIT ASSEMBLY
3. INSTALL ROOF HEADLINING ASSEMBLY
HINT: Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY".
4. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY
5. INSPECT STEERING WHEEL CENTER POINT
6. INSTALL STEERING PAD
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.
9. INSPECT SRS WARNING LIGHT
Reverse Signal Circuit
DESCRIPTION
The radio and navigation assembly receives a reverse signal from the
park/neutral position switch and
information about the GPS antenna, and then adjusts vehicle position.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT RADIO AND NAVIGATION ASSEMBLY
Disconnect the radio ...
Side Airbag Sensor Assembly LH Circuit Malfunction
DTC B1141/33 Side Airbag Sensor Assembly LH Circuit Malfunction
DESCRIPTION
The side airbag sensor LH circuit consists of the center airbag sensor
assembly and side airbag sensor
LH.
If the center airbag sensor assembly receives signals from the side airbag
sensor LH, it judges whether or
...
Knock Sensor 1 Circuit Low Input
DESCRIPTION
A flat type knock sensor (non-resonant type) has a structure that can detect
vibrations over a wide band of
frequencies: between approximately 6 kHz and 15 kHz.
Knock sensors are fitted onto the engine block to detect engine knocking.
The knock sensor contains a piezoelectr ...