1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
NOTICE:
Torque: 17.5 N*m (179 kgf*cm, 13 ft.*lbf)
2. INSTALL AIR DUCT NO.1 REAR
3. INSTALL AIR DUCT NO.3 REAR
4. INSTALL AIR DUCT NO.4 REAR
5. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY LOWER CENTER
6. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER
7. INSTALL INSTRUMENT PANEL BOX NO.2
8. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
9. INSTALL FLOOR CARPET COVER CENTER LH
10. INSTALL FLOOR CARPET COVER CENTER RH
HINT: Use the same procedures for the floor carpet cover center RH and floor carpet cover center LH.
11. INSTALL INSTRUMENT PANEL FINISH PANEL SUBASSEMBLY LOWER LH
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
13. PERFORM INITIALIZATION
HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.
14. INSPECT SRS WARNING LIGHT
Short to B+ in Door System Communication
Bus Malfunction/ Short to GND in Door System Communication
Bus Malfunction
DTC B1214 Short to B+ in Door System Communication
Bus Malfunction
DTC B1215 Short to GND in Door System Communication
Bus Malfunction
DESCRIPTION
DTCs B1214 and B1215 are output when a short to +B or the body ground occurs
on the communication
bus. Detecting this condition disables all the ...
Installation
1. INSTALL INSTRUMENT PANEL SAFETY PAD SUBASSEMBLY
Using a torque wrench, install the bolt <B>.
Torque: 20 N*m (204 kgf*cm, 14 ft.*lbf)
2. INSTALL SHIFT LEVER ASSEMBLY
Using a torque wrench, install the 4 bolts.
Torque: 21 N*m (214 kgf*cm, 12.6 ft.*lbf)
3. ...
Pressure Control Solenoid "C" Performance (Shift
Solenoid Valve SL3)
SYSTEM DESCRIPTION
The ECM uses signals from the vehicle speed sensor to detect the actual gear
position (1st, 2nd, 3rd, 4th
or 5th gear).
Then the ECM compares the actual gear with the shift schedule in the ECM memory
to detect mechanical
troubles of the shift solenoid valves and valve bo ...