Toyota Sienna Service Manual: Installation
1. REMOVE FRONT SEAT INNER BELT ASSEMBLY
HINT:
- Refer to the instructions for reassembly of the front seat assembly (for flat type).
- Refer to the instructions for reassembly of the front seat assembly (for manual seat).
- Refer to the instructions for reassembly of the front seat assembly (for power seat).
- Install the front seat inner belt assembly with the
nut.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
Inspection
1. INSPECT FRONT SEAT INNER BELT ASSEMBLY RH
Release the seat belt (Buckle switch is ON).
Check the resistance between the terminals.
Standard
If the result is not as speci ...
Front seat outer belt assembly
COMPONENTS
...
Other materials:
Inspection
1. INSPECT MAGNETIC CLUTCH CLEARANCE
(a) Set the dial indicator to the magnetic clutch hub.
(b) Connect the battery positive lead to the terminal 1 of
the magnet clutch connector and the negative lead
to the earth wire. Turn on and off the magnetic
clutch and measure the clearance.
Stand ...
On-vehicle inspection
1. INSPECT BACK WINDOW (DEFOGGER WIRE)
NOTICE:
When cleaning the glass, wipe the glass along the
wire using a soft and dry cloth. Take care not to
damage the wires.
Do not use detergents or glass cleaners including
abrasive ingredients.
When measuring voltage, wr ...
Terminals of ECU
1. MULTIPLEX NETWORK GATEWAY ECU
Disconnect the G4 ECU connector.
Measure the voltage between the specified
terminals on the wire harness side connector.
If the result is not as specified, there may be a
malfunction on the wire harness side.
Measure the resistance between ...
