1. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for center seat).
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
2. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 7-Passenger)
HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for captain seat type).
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
3. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY
HINT:
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
4. INSTALL REAR SEAT INNER BELT ASSEMBLY
HINT:
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
Inspection
1. INSPECT CHARCOAL CANISTER ASSEMBLY
(a) Visually check the charcoal canister for cracks or
damage.
If cracks or damage are found, replace the charcoal
canister assembly.
(b) Check charcoal canister operation.
(1) With the purge port closed, blow 1.67 kPa (17.0
gf/cm2, 0.24 psi) ...
Pressure Control Solenoid "A" Performance (Shift Solenoid
Valve SL1)
SYSTEM DESCRIPTION
The ECM uses signals from the vehicle speed sensor to
detect the actual gear position (1st, 2nd, 3rd, 4th
or 5th gear).
Then the ECM compares the actual gear with the shift schedule in the ECM memory
to detect mechanical
problems of the shift solenoid valves, valve b ...
On-vehicle inspection
1. CONNECT INTELLIGENT TESTER
(a) Connect the intelligent tester to the DLC3.
(b) Start the engine and run at idle.
(c) Select the ACTIVE TEST mode on the intelligent
tester.
HINT:
Please refer to the intelligent tester operator's
manual for further details.
2. INSPECT ACTUATOR MOTOR ...