1. INSTALL NO. 2 REAR SEAT OUTER BELT ASSEMBLY
NOTICE: Do not disassemble the retractor.
If operation is not as specified, replace the No.
2 rear seat outer belt assembly.
Torque: Upper bolt
8.5 N*m (87 kgf*cm, 75 in.*lbf)
Lower bolt
42 N*m (430 kgf*cm, 31 ft.*lbf)
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
2. INSTALL 3 POINT TYPE REAR SEAT BELT ASSEMBLY (for 8-Passenger)
NOTICE: Do not disassemble the retractor.
If operation is not as specified, replace the 3 point type rear seat belt assembly.
Torque: Upper bolt
8.5 N*m (87 kgf*cm, 75 in.*lbf)
Lower bolt
42 N*m (430 kgf*cm, 31 ft.*lbf)
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
NOTICE: The check should be performed with the assembly installed.
If operation is not as specified, replace the belt 3 point type rear seat belt assembly.
NOTICE: The check should be performed with the assembly installed.
If operation is not as specified, replace the 3 point type rear seat belt assembly.
3. INSTALL NO. 1 REAR SEAT OUTER BELT ASSEMBLY (for 7-Passenger)
HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for captain seat type).
If operation is not as specified, replace the No.
1 rear seat outer belt assembly.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
NOTICE: The check should be performed with the assembly installed.
If operation is not as specified, replace the No.
1 rear seat outer belt assembly assembly.
NOTICE: The check should be performed with the assembly installed.
If operation is not as specified, replace the No.
1 rear seat outer belt assembly.
4. INSTALL REAR WINDOW SIDE GARNISH ASSEMBLY
5. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf) NOTICE: Do not make the anchor part run onto the protrusion part of the floor panel.
NOTICE: The check should be performed with the assembly installed.
6. INSTALL BACK DOOR SCUFF PLATE
7. INSTALL BACK DOOR WEATHERSTRIP
8. INSTALL REAR DOOR WEATHERSTRIP
9. INSTALL REAR DOOR SCUFF PLATE
Installation
1. INSTALL SEAT POSITION AIRBAG SENSOR
Check that the ignition switch is off.
Check that the negative battery (-) terminal is
disconnected.
CAUTION:
After disconnecting the negative battery
terminal, wait for at least 90 seconds before
starting the operation.
...
Installation
1. TEMPORARILY TIGHTEN AIR CONDITIONING UNIT ASSEMBLY
(a) Engage the 2 claws.
(b) Temporarily tighten the air conditioning unit
assembly with the nut.
Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
2. INSTALL LOWER DEFROSTER NOZZLE ASSEMBLY
(a) Engage the 4 claws and install the lower defr ...
Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2. REMOVE ENGINE UNDER COVER NO.1
3. DRAIN AUTOMATIC TRANSAXLE FLUID
(a) Remove the drain plug and gasket, and drain the
ATF.
(b) Install a new gasket and the drain plug.
Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
4. REMOVE AUTOMATIC TRANSA ...